Fork-Co: FORK - ITA Class III, 1.75x5x42, Full Taper Polished, Minimum Order Qty of 2 pieces.
|ITA / FEM Class: ITA Class III|
|Fork Length: 42" (42 Inches)|
|Taper Style: Full Taper & Polish|
ITA Class III Forklift Forks 1.75" x 5" x 42" Full Taper (6,9700lbs @ 24" Load Center)
Often referred to as Lumber Forks or Plywood Forks, these fork tines are different than standard taper forks in the sense that the taper starts near the heel and continues all the way to the the tip of the fork.
Tips on fully tapered forks are typically squared off, with a chisel tip making them on the tips thinner than standard forks. The purpose of this style fork is to effectively and efficiently lift bundles of wood building material without damaging the load with a forged finish or narrower contact surface.
FTP Style Forks are also used frequently when "scooping" un-palletized loads directly off of the ground or floor. The Full Bottom Taper allows the chisel tip to sit directly on the ground to be effective in this application.
Check out the Tabs on the Forks Overview Page for more information on Full Taper ITA Class III Forks!
Other Common Sizes:
T x W x L
Capacity @ 24" LC
|3-150548FT||ITA Class III||1.50" x 5" x 48"||5,500||Click here to Buy Now|
|3-150648FT||ITA Class III||1.50" x 6" x 48"||6,800||Click here to Buy Now|
|3-150742FT||ITA Class III||1.50" x 7" x 42"||8,160||Click here to Buy Now|
|3-150748FT||ITA Class III||1.50" x 7" x 48"||8,160||Click here to Buy Now|
|3-150848FT||ITA Class III||1.50" x 8" x 48"||9,180*||Click here to Buy Now|
|3-1501048FT||ITA Class III||1.50" x 10" x 48"||11,390*||Click here to Buy Now|
|3-175542FT||ITA Class III||1.75" x 5" x 42"||6,970||Click here to Buy Now|
|3-175548FTP-A||ITA Class III||1.75" x 5" x 48"||6,970||Click here to Buy Now|
|3-200648FTP-A||ITA Class III||2" x 6" x 48"||10,700*||Click here to Buy Now|
|3-200660FTP-A||ITA Class III||2" x 6" x 60"||10,700*||Click here to Buy Now|
* Forks capacity shown is greater than the 9,000lb maximum capacity of an ITA Class III Carriage. The capacity rating of the Forks in no way increases the capacity of the forklift. The Forklift Manufacturer's Capacity Rating always prevails.